HYUNDAI H-SWE1-80 V-UI 067 инструкция по эксплуатации онлайн - Страница 13. Hyundai h swe1 80v ui067


HYUNDAI H-SWE1-80 V-UI 067 инструкция онлайн просмотр

background image

8.

Electrical instant water heater

EN

Installation/connection safety and precautions

• Installation of the water heater in the operation place and arrangement of a power supply 

line shall be performed by a specialized organization, representatives of the manufacturer’s service department, or specialists having permits for installation of electrical equipment with observation of the safety requirements.

• If the water heater installation/operation instructions are violated, the appliance is not subject 

to warranty service and the manufacturer does not bear the responsibility.

• Never install the water heater outdoors.• Before installation and connection of the water heater to the electrical mains, check and make 

sure that the mains socket for the water heater has a grounding contact and it is properly grounded. If there is no grounding loop in your electrical mains, operation of the water heater is hazardous for life.

• Connect the water heater to 220 VAC / 50 Hz mains only. If necessary, clarify specifications of 

your electrical mains from the electrical energy suppliers.

• To avoid overheating and risk of fire / damage of the internal electrical circuit, do not change 

length of the power cord and do not connect the water heater via electrical extension cables.

• Make sure that the electrical cable does not cross sharp edges or contact with hot surfaces.• To avoid air pockets and breakdown of the appliance, the water heater shall be installed strict-

ly in vertical position with its connections downward.

• Do not swap locations of the water inlet and outlet positions, since this will result in break-

down of the water heater and may inflict harm to the user (see color marks - blue for water inlet and red for water outlet).

Operation/cleaning safety and precautions

                    CAUTION!

                                    Do not switch on the water heater, if water may freeze in it.

• The water heater is designed only for household use indoors in closed spaces. The water 

heater is not designed for industrial use.

• The water heater is designed only for heating of water. Do not use the appliance for heating of 

other liquids. This may inflict a severe damage to the water heater, other property, or result in a personal injury.

• Never switch on the water heater, if it is not filled with water or water cannot flow through the 

pressure safely valve.

• Water temperature in the water heater may reach 75°C. Therefore, do not place body parts 

under hot water upon first switching of the water heater. For prevention of burns, properly adjust outlet temperature of water.

• Do not remove the protection covers of the water heater during its operation or before 

de-energization.

• Immediately disconnect the water heater from the electrical mains in case of strange sounds, 

odor, or smoke from it.

• Do not use the water heater with the damaged electrical cable or other damages.• For troubleshooting and repairs, please contact the nearest authorized service center of the 

manufacturer in your region.

• Before cleaning or maintenance of the water heater, always disconnect it from the electrical 

manualbase.ru

HYUNDAI H-SWE1-80 V-UI 067 инструкция онлайн просмотр

background image

11.

Electrical instant water heater

EN

                  CAUTION! 

                                    Proper grounding is important for minimization of electrical shock                                     and fire hazards.

The water heater is designed for connection to the electrical mains with single-phase voltage of 220V. Before connection, make sure that parameters of the electrical mains at the connection point meet the parameters indicated on the name plate with specifications of the appliance. During installation of the water heater, observe the effective electrical safety rules. The electrical socket shall be designed for rated current not less than 10A. The electrical cable shall have conductor area not less than 3x1.5 mm2 (for copper).

OPERATION

1 - Heating indicator2 - ECO position3 - Thermostat knob4 - Maximum water heating temperature position5 - Off position

Approximate

temperature scale

4

5

2

1

3

CAUTION!

Refer to «Water heater safe operation and installation rules»

Open one of the demountable valves at outlet from the water heater and open the cold water inlet valve. When water starts to freely flow out from the demountable valve, close it and insert the plug of the power cord to the socket. When the water heater is used, the cold water inlet valve shall be in open position.The water heating temperature in the water heater can be set in the range from +35°C to +75°C. To increase the water heating temperature, rotate the thermostat knob clockwise. To decrease the water heating temperature, rotate the thermostat knob counter-clockwise.The water heater automatically maintains the set water temperature. When water temperature in the water heater reaches the user set value, heating will be automatically stopped and the heating indicator will extinguish. When water temperature in the water heater decreases below the user set value, heating will be automatically activated and the heating indicator will light up with bright pink color.

0°C

75°C

35°C

61°C

68°C

45°C

55°C

manualbase.ru

HYUNDAI H-SWE1-80 V-UI 067 инструкция онлайн просмотр

background image

7.

Electrical instant water heater

EN

* Dimensions are given in mm with permissible variations of 1-5 mm

30l

50l

80l

100l

WATER HEATER SAFE OPERATION AND INSTALLA-

TION RULES 

Always observe the safety rules, when using the water heater. Improper operation due to igno-rance of these rules may result in personal injury to the user or other people, as well as damage to their property. The manufacturer is not responsible for inflicted personal injuries and property damages as a result of improper installation and operation of the appliance.

Safety of children and people with physical disability

• The water heater is not designed for use by people (including children) with physical, sensory, 

or mental disability having insufficient experience and knowledge, if they are not supervised or instructed on use of the appliance by a person responsible for their safety.

• Any electrical appliance shall be supervised during its operation, especially if there are chil-

dren close by.

• Carefully watch that children do not touch the appliance or use it as a game element.• Do not allow children to use the water heater without supervision by adults.

General safety rules

• Never change the design of the water heater or modify it.• Never use the water heater, if it is faulty.• Do not use the water heater in explosive or corrosive environment. Do not store gasoline and 

other volatile highly inflammable liquids near the appliance.

• Do not use the water heater for purposes not specified in this instruction manual.• Never splash water onto the heater or irrigate it.• Any service operations shall be performed by a specialized organization, by qualified                  

specialists.

110 mm

12 mm

84 mm

84 mm

139,5 mm

154 mm

257 mm

176 mm

297 mm

447 mm

141 mm

177 mm

141 mm

264 mm

141 mm

264 mm

84 mm

84 mm

manualbase.ru

HYUNDAI H-SWE1-80 V-UI 067 инструкция онлайн просмотр

background image

13.

Electrical instant water heater

EN

CAUTION!

If these actions do not give a positive result or the thermal switch trips on repeated occasions for a short period of time, then switch off the water heater, shut off water feeding to the water heater, and contact the authorized service center of Hyundai in your region for consultation or repair of the product.

If a drain valve and a tee are not provided (refer to “Water supply network connection”), you can drain water through the combined check valve / pressure safety valve. For that, unscrew the screw of the drain lever on the combined check valve / pressure safety valve and place the drain lever to the top position. At that, the hot water outlet valve shall be opened, while the cold water inlet valve of the water heater shall be closed.

Drain lever

Screw

Pressure relief port

Please carry out test checks of the pressure safety valve for operability every 14 days as follows:- place the drain lever to the top position until you feel transition of thread and then water will flow from the valve port. After you have confirmed that water flows out, return the lever to the previous position.

Wipe the outer surfaces of the water heater with a moist cloth and soap as necessary.

CAUTION!

Never drain water, if its temperature exceeds 50°C, since it may result in burns.

CAUTION!

If water does not flow, this means that the valve is faulty. In this case, the water heater shall not be used and we recommend you to call a specialist of the service center.

manualbase.ru

HYUNDAI H-SWE1-80 V-UI 067 инструкция онлайн просмотр

background image

3.

Electrical instant water heater

EN

INTRODUCTION

Before installing and using the appliance, please very carefully read this instruction manual and manufacturer’s warranty liabilities. Keep the instruction manual for future reference. If you hand over the appliance to another user, please hand over the instruction manual as well.

For more details or resolution of any occurred problems, please visit Hyundai website at www.hyundai-hvac.com. You can also contact the nearest regional service center of the manufacturer. If there are no service centers of the manufacturer in your region, please contact the regional dealer of Hyundai.

The content of this instruction manual has been checked and approved. The manufacturer is not responsible for any spelling mistakes in the text and incorrect interpretation of the instruction manual content.

The appearance, specifications, and package contents of the appliance can be modified by the manufacturer without preliminary notification.

GENERAL

Description

Electrical tank water heaters are used for supply of hot water in country houses, cottages, baths, and other utility spaces, which are not connected to the central hot water supply network. Such heaters can also be used as standby equipment in apartments for the preventive maintenance period of the hot water supply network.

The operation principle of the water heater assumes that water pressure in the water heater meets water pressure in the water main. As water is consumed, the water heater tank is continu-ously refilled with cold water.

The electrical tank water heater of Niagara series is designed for heating of tap water in house-hold use. It is capable to prepare a lot of hot water and maintain the set temperature auto-matically. The water heater has a steel outer casing. Water is heated in a steel enameled tank using a copper heating element. Heat insulation made of an environmentally friendly material is provided between the outer casing and steel tank. The dense insulation layer ensures reduction of heat loss and significant saving of electrical energy.

For mitigation of corrosion effect and provision of consumers with water free from contamina-tion, the water heater is equipped with a magnesium anode of extended length. The water heater has a water heating indicator and a water temperature control knob located on the bottom cover. The knob controls an integrated thermostat allowing the user to set various water heating temperatures in the range from +35°C to +75°C. A temperature limiter installed in the appliance excludes overheating of water above 88°C, while a combined check valve / pressure safety valve ensures safe operation of the water heater. If pressure inside the tank exceeds 0.75 MPa, the pressure safety valve will automatically open and exclude rupture of the casing.

 

manualbase.ru

HYUNDAI H-SWE1-80 V-UI 067 инструкция онлайн просмотр

background image

12.

Electrical instant water heater

EN

MAINTENANCE

Check the electrical plug and socket as often as possible. Secure electrical contact and proper grounding shall be assured. The plug and socket shall not heat up abnormally.If the water heater is not used for a long period, especially in regions with low ambient tempera-tures (below 0°C), water shall be drained from the water heater in order to prevent its damage (due to water freezing in the internal tank).To ensure reliable operation of the water heater for a long time, periodically clean the internal tank and remove deposits from the electrical heating elements of the water heater. In addition, periodically check condition of the magnesium anode (whether it is fully dissolved or not) for its timely replacement with a new one in case of full dissolution. The tank cleaning frequency depends on local water hardness.

Cleaning shall be carried out by specialized service departments. The address of the nearest service center can be obtained from the vendor or at www.hyundai-hvac.com. Preventive mainte-nance operations shall be carried out with strict observation of the instruction manual and safety rules.The water heater is equipped with a thermal switch, which will cut off supply of electrical energy to the electrical heating element in the event of water overheating/absence in the water heater. If the water heater is switched on, but water is not heated, this means tripping or need for reset of the thermal switch. To return the water heater to the operational condition, proceed as follows:- disconnect the water heater from power supply and remove the molding of the bottom cover;- press the button at the center of the thermal switch until the button clicks;- if the button is not pressed and there is no click, wait until the thermal switch cools down to the initial temperature.

CAUTION!

During heating, water may begin to drip from the port of the pressure safety valve. Water leakage cannot be avoided and shall not be prevented, since blocking of the valve may result in rupture of the internal tank (in case of equipment breakdown).

CAUTION!

Refer to «Water heater safe operation and installation rules»

CAUTION!

The manufacturer provides an extended warranty, when preventive main-tenance operations are carried out (refer to the warranty card).

Placement of the thermostatic controller knob to the ECO position selects the mode, which cor-responds to the most comfortable water heating temperature in the water heater (+58°C (±2°C)) and most efficient electrical energy consumption. To switch off the water heater, place the ther-mostat knob to the leftmost position and disconnect the water heater from the electrical mains.

manualbase.ru

HYUNDAI H-SWE1-80 V-UI 067 инструкция онлайн просмотр

background image

14.

Electrical instant water heater

EN

Water is not heated

Water does not flow from the hot water outlet valve

Water temperature is too high

Water leakage

Water flows out from the appliance casing

1. The temperature control-ler is damaged.

2. The temperature limiter is tripped or not activated.

3. The temperature limiter is damaged.

4. Insufficient time for heating.

5. The heating element is damaged.

1. Water feeding is shut off.

2. Water pressure is too low.

3. The cold water feed valve is closed.

The water temperature con-trol system is damaged.

The seal at the connec-tion point of the pipes is disturbed.

1. The internal tank is corroded

2. The seal at the connection point of the heating element is disturbed.

1. Contact a repair specialist in the Hyundai service center.

2. Activate the thermal switch observing relevant guidelines.

3. Contact a repair specialist in the Hyundai service center.

4. Wait until water is heated.

5. Contact a repair specialist in the Hyundai service center.

1. Wait until water feeding is restored.2. Switch on the water heater again, when normal water pres-sure is restored.3. Open the cold water feed valve.

Contact a repair specialist in the Hyundai service center.

Replace the connection seal.

1. Contact a repair specialist in the Hyundai service center.

2. Contact a repair specialist in the Hyundai service center.

Failure

Possible causes

Remedy

TROUBLESHOOTING

manualbase.ru


Смотрите также